Digisol DG-FS4528P, Management Manual

Page: 705 / 973

C
HAPTER
30 | Power over Ethernet Commands
– 705 –
If auto-recovery is enabled, when an overload condition is detected on
a port, the switch will continuously power-cycle the port to check its
status. If the overload is no longer detected on the port, it will be
automatically re-enabled.
E
XAMPLE
Console(config)#interface ethernet 1/1
Console(config-if)#power inline overload-auto-recover
Are you sure the PoE port(s) remain enabled during power overload? [y/n]
Console(config-if)#
power inline priority
This command sets the power priority for specific ports. Use the no form to
restore the default setting.
S
YNTAX
power inline priority priority
no power inline priority
priority - The power priority for the port.
Options: 1 (critical), 2 (high), or 3 (low)
D
EFAULT
S
ETTING
3 (low)
C
OMMAND
M
ODE
Interface Configuration
C
OMMAND
U
SAGE
If the power demand from devices connected to the switch exceeds the
power budget setting as determined during bootup, the switch uses
port power priority settings to control the supplied power. For example:
A device connected to a low-priority port that causes the switch to
exceed its budget is not supplied power.
If a device is connected to a critical or high-priority port and causes
the switch to exceed its budget, port power is still be turned on if
the switch can drop power to one or more lower-priority ports and
keep within its budget.
Power will be dropped from low-priority ports in sequence starting
from port number 1.
If sufficient power cannot be freed up for a critical or high-priority
port by turning off power to lower-priority ports, power will not be
supplied to the newly connected device.
If a device is connected to a port after the switch has finished booting
up and would cause the switch to exceed its budget, power will not be
provided to that port regardless of its priority setting.