DR4024 DIGISERVO (v1.31)
Pagina / page / Seite / page 19
PRESET 0
(STANDARD)
4 servos (1-4) and 4 separate switching outputs (5-8)
Preset 0 automatically gives the module 8 outputs.
1-4 are reserved for the 4 servo outputs.
5-8 are reserved for the 4 extra switching outputs OUT5 - OUT8
.
PRESET 1
4 servos (1-4) with connected switching outputs (1-4)
Preset 1 automatically gives the module 4 addresses (1-4).
The extra switching outputs are coupled with the servo outputs,
whereby the extra switching outputs will switch when the servo rea-
ches the midway position. This preset is for when you attach a relay
for point (US: railroad switch) polarisation to the switching output.
PRESET 2
4 servos with mass simulation (1-4) and 4 separate switching outputs (5-8)
Preset 2 automatically gives the module 8 outputs. 1-4 are reserved for
the 4
servo outputs S1-S4, whereby the mass simulation
is automatically ac-
tivated on each servo output. 5-8 are reserved for the 4 extra swit-
ching outputs OUT5 - OUT8.
_1_
_2_
_3_
_4_
6
7
8
5
1
2
3
4
6
7
8
5
1
2
3
4
PRESETS
There are four preset CVs to make programming a little easier.
The presets are programmed in CV47. This write-only CV automatically sets a number of standard effects. You
cannot read this CV at a later time.
Let your imagination run wild by using the presets as a starting point
for setting up other effects. For example, you might use preset 2 as a
basis for a signal which influences a train’s behaviour: Adjust the
function mapping so that the outputs switch along with the servos
and set up the output configuration so that it switches when the
green mode is reached.
Important: The servo speed and end positions are not adjusted
by the presets!
PRESET 3
Crossing with AHOB, 2 barriers and mass simulation
