ENGLISH
21
The signal is too weak because of bad weather conditions, for
example: wait for the signal to recover.
Remote control does not operate the decoder
Make sure the decoder is turned on.
Make sure that the remote control is pointing towards the front
panel of the decoder and that there are no obstructions on the
path.
Check the remote control batteries: they may have been
inserted in the wrong direction or discharged.
Check that no liquid has leaked from the batteries.
Check that there are no stuck keys.
Make sure that there is no direct sunlight on the decoder.
A temporary transmission error has occurred, or the decoder
software has lost some of its settings. Turn the unit off and
disconnect it from power; allow a few minutes to elapse and
then turn it on again.
Make sure that there are no transmitters in the vicinity that
could interfere with remote control actions.
An incorrect function has been selected. Press the right key.
Verify that the decoder is properly connected to the power outlet
and TV.
Try using the TV remote control.
No image or “No Signal" message
When connecting the decoder with HDMI, you may need to
select the source (e. g. HDMI1) for the input used by pressing
the SOURCE button on the TV remote control (depending on
the brand, it can also be identified with INPUT, AV, AUX,
ZERO, etc.).
Check the HDMI or SCART cable
.
Disconnect and then reconnect the decoder.
"No Signal Absence" appears on the channel already
tuned
Reset the decoder (see relative paragraph), or check the
system status.
The word Codified (Scrambled) appears
The channel viewed is part of a paid package.
The image appears crushed or cut
The picture format in the
AV setting > Aspect mode
menu has
not been set according to the TV's characteristics. Try another
format.
Summary of Contents for XSD2.1
Page 1: ......
