Page
w w w
.
d i g i m e r g e
.
c o m
DND70 Series_Quick Installation Guide_En_R1
HARDWARE CONNECTIONS
1
Continued
Hardware Installation - Adjusting the Lens
NOTE:
The lens should be adjusted prior to
reattaching the camera cover. If you are adjust-
ing the Camera using a direct connection to a
PC, you will need to use a Crossover Ethernet
Cable, or use the BNC Analog Output.
1. Adjust the Angle, Zoom and Focus
controls:
i. Loosen the two screws on the side of the
Lens. Adjust the Angle of the Lens
assembly, and tighten the screws to hold
the assembly in the desired position.
ii. Use a screwdriver to loosen the Zoom screw.
Move the adjusting screw left and right to
turn the Zoom Ring. Once the lens is set to
the desired Zoom, tighten the screw to hold
the lens placement.
iii. Use a screwdriver to loosen the Focus
screw. Move the adjusting screw left and
right to turn the Focus Ring. Once the lens
is set to the desired Focus, tighten the
screw to hold the lens placement.
iv. Replace the Cover on the Camera Base
and attach with the 4 securing screws with
the Security Hex tool.
B
1i
ZOOM
RING
1ii
1iii
SCREW 1
SCREW 2
FOCUS
SCREW
