DND70 Series_Quick Installation Guide_En_R1
w w w
.
d i g i m e r g e
.
c o m
Page
• Hardware installation:
A. Installing the Base
B. Adjusting the Lens
C. Connecting the Cables
• Software installation
• Network configuration
HARDWARE CONNECTIONS
1
2i
Hardware Installation - Installing the Base
NOTES:
• If you wish to change the Cable Location (Cable
Conduit), please refer to User Manual Appendix #2
prior to installation.
• Do not remove the Dome Cover Plastic Protector
until the end of the installation.
1. Remove the Cover from the Camera
by removing
the 4 securing screws using the large silver
proprietary Hex Tool.
2. Attach the base to a Wall or Ceiling:
i. Hold the base up to the desired location. Use a
Pencil or Marker to mark the 4 hole locations.
ii. Use a drill with the correct bit type, and drill
holes on the marked positions. Hammer the
Screw Plugs (included with the Hardware Pack)
into the holes.
iii. Place the rubber washer onto the screw (both
provided with the Hardware Pack). Repeat for all
screws.
iv. Use a screwdriver to install the 4 screws through
the holes in the base into the mounting surface.
A
1
2ii
2iii
2iv
