OpenLogger™ Acrylic Case Assembly Manual
Copyright Digilent, Inc. All rights reserved.
Other product and company names mentioned may be trademarks of their respective owners.
Page
9
of
12
Step 5
Make sure that the assembly from Steps 2 through 3 is in the same orientation as in those steps and the assembly
from Step 4 is in the same orientation from that step. Place each assembly side by side as shown in Figure 12. Pick
up the assembly from Step 4, flip it horizontally as shown in Figure 13 such that it is upside down. Then, place it on
top of the assembly from Steps 2 through 3 such that the vertical facing screws appear through the holes in the
assembly from Step 4 as shown in Figure 14. Make sure all the notches align with their respective parts on the
OpenLogger while being careful not to bend the acrylic.
Figure 12:Both Assemblies Side bySide with CorrectOrientation
Figure 13:Flip Over Assembly on RightSide.
