DK50018
-
Bluetooth accessory and switching decoder Bluetooth connection
DK50018
-
Bluetooth accessory and switching decoder
www.digikeijs.com
*R
-
Bus, B
-
Bus are registered trademarks of Modelleisenbhan GmbH. XpressNet and RS
-
Bus are registered trademarks of Lenz 33
www.digikeijs.com
www.digikeijs.com
5.1 Program mode does not stay active
Some control units have the following problem:
when pressing the programming button on the DK50018, the yellow LED goes off again shortly after the programming mode has been activated and the
DK50018 automatically terminates the programming mode. This happens only if the locomotive address 9999 has not been taken into account by the
control unit. This can be easily bypassed by activating the locomotive address 9999 before pressing the programming button o
f
the DK50018.
To prevent the red LED from going off, please use the following procedure for POM programming:
1.
Set the locomotive address to 9999 (in DCC 128 steps) in your control unit or application.
2.
Activate the locomotive with the above address in your control unit or application by switching the lights on/off (F0).
3.
Press the programming button of the DK50018 only then, the LED must light up which means that the module is waiting for programming.
4.
Now change the selected CV's via the POM mode to address 9999.
5.
To exit the DK50018 "Programming" mode, press the button on the module again and the yellow LED on the decoder must go off, which means the
modification has been saved.
