Functions of the 7.1 version compared to the 6.9
Additional improvement
Automatic start of "Peak recorder”.
New parameters setup:
The new function of the Flyer allows through the parameter
to select the starting recording modality.
The three regulations are:
Manual Start (see instructions).
Start when turning on the instrument.
Start when takeoff in function of
and
parameters.
These two parameters
serve to describe the barometric
conditions in order to consider valid the takeoff and therefore to
start the recording.
With the parameters set by Digifly Europe, a takeoff is considered
valid when there is a barometric variation major of 2 mt in less
than 4 seconds.
To STOP the recorder: press the key
, the message "
" will
appear and then press the key
within two seconds to confirm.
With
= 1 in order to end recording, just press the key
or
turn it off pressing the
key for at least 3 seconds.
(0=OFF 1=ALWAYS 2=AUTO (dft 2)) /
(1..30)
Variation in MT (default = 2)
(1..30)
maximum time of variation in SEC.
(default = 4).
This takeoff analysis is continuously carried out after turning on
the vario and is also regulated from a special filter that controls the
effective trend (of lifting or descending).
Auto scaling function: when the quota is lower than -999mt (or ft)
or is more than 19999mt (or ft), the altimeter scales automatically
"/10 " and the pointer mt or ft begins to flash.
15 AUTR
0 =
1 =
2 =
16 R-mT
17 R-TI
16 - 17
stop
AUTR
15 AUTR
16 R-MT
17 R-TI
Summary of Contents for Flyer
Page 1: ...User manual Vl100 flyer rev 1 3 firm 7 1 ...
Page 12: ...Notes Page 11 ...
Page 13: ...Notes Page 12 ...
