Page
2
P/N: RF159IRG Rev 1.3
E&OE
Copyright © 2020
The 2 Channel SMART RF Controller is an advanced
433MHz stand-alone transceiver that can be used to
arm/disarm an alarm system and operate an auto gate
or garage door. The two relay outputs are fully program-
mable and controlled by up to 250, RF110 Keyfobs.
The unit is compact so it can easily fit inside a gate
controller cabinet or can be mounted easily to most
surfaces. The wide operating voltage 9 to 28 volts AC/DC
makes it easy to power from third-party controllers or
power supplies.
This unit also compliments the Digiflex RF family allow-
ing you to control different devices in diverse locations
using the same Digiflex Smart RF Keyfobs.
The 2-way communication protocol is encrypted with
rolling code and anti substitution technology making
the RF159 an ideal choice for controlling gates, garage
doors, lights or security systems.
Box Contents
The RF159 box contains the following parts.
2CH SMART RF Controller
1x Antenna
Instruction Sheet
Compatible Keyfobs
RF110 Smart 5 Button Keyfob
RF110FK - Colour Facia Kit One Of Each Colour
(Red, Blue, Green, Orange, Black, Grey, Yellow)
Figure 1: RF110 Smart 5 Button Keyfob
RF159 - 2CH SMART RF Controller - 433MHz
Mounting Considerations:
•
The receiver should be mounted in a location at least
2m from other receivers.
•
The receiver should be mounted on a vertical
surface with at least 30 cm clearance from metal
objects.
•
Avoid mounting the receiver in areas with significant
metal or electrical wiring.
•
Avoid mounting the receiver in areas where it may
be exposed to moisture or high humidity.
•
Reception distances are generally improved with
higher mounting locations and with no metal ob-
jects near the unit.
•
If range is not achievable due to environmental or
specification limitations then look at relocating the
unit to a more appropriate location.
Defaulting
There are 3 default modes which allow you to manage
and reset the settings as needed.
Default Mode 1:
Factory Default
-
Hold down both RLY1 & RLY2 while applying power.
RLY1 = Pulse 2 seconds
RLY2 = Pulse 2 seconds
Keyfobs: All Deleted
Default Mode 2:
Erase only keyfobs that have not been
used in the last
60
days.
- Hold down RLY1 while applying power.
RLY1 = No Change
RLY2 = No Change
Keyfobs: Deleted If Not recently Used
Default Mode 3:
Erase all Keyfobs
- Hold down RLY2 while applying power
RLY1 = No Change
RLY2 = No Change
Keyfobs: All Deleted
