P/N: CM743IRG Rev 1.6
Page
3
Copyright © 2014
E&OE
CLI Triggers
The CLI trigger tables in MENU 6-5-5-1 and 6-5-6-2 can
be used to store a list of telephone numbers that can
trigger an output on the control panel. If you call the
GSM unit from a telephone number that matches a num-
ber in the CLI list then the appropriate output will be
operated.
An output needs to be programmed with an event type
of CLI Trigger and event assignment of 1 or 2 depending
on which table is to be checked.
Simply call the GSM unit from a telephone number that
is programmed in the CLI trigger list to activate the
output.
Module Status
MENU 6-5-0 can be used to obtain various information
on the radio module. The following information is cur-
rently available.
1) Connected Network
2) Signal Strength in dB
3) IMEI Number
4) Radio Firmware Revision
5) SIM Card Present
Dial Number Test
It is possible to check the SIM phone number by select-
ing the dial number test via GSM option in MENU 5-9-5.
SMS Remote Control
The SMS control option in MENU 6-5-6 allow you to pro-
gram up to 10 telephone numbers that are allowed to
send SMS commands to the GSM unit. The first number
in this list is considered as the administrator who will
also receive SMS messages that the GSM unit is unable
to interpret. i.e. any message sent to the radio which
cannot be interpreted will be sent back via SMS to the
first number in the SMS control number list.
Numerous commands can be sent to the panel using
the SMS control functions including arming/ disarming
areas, controlling outputs and doors or checking system
status. The panel can also be requested to send a confir-
mation SMS if required.
The control messages must be sent to the SIM phone
number.
The following table shows the correct method for con-
structing the SMS messages. Note there are no spaces
between the fields only commas as shown.
The MyAlarm SMS Control App for iOS and Android
devices is now available and can be used to simplify the
configuration and sending of SMS control messages.
You can search for the app in the app store or scan the
QR codes below using your device’s barcode reader for a
direct link to the app.
