Before the first use
1. Open the Protection Cover and slide the power switch to the On position. Hint: to increase the
lifespan of the battery, slide the power switch to Off for both the dongle and earset when not
in use.
2. Please charge the battery for at least than 2 hours.
Red LED on the power button is on while charging and LED is turned off when charging is completed.
NOTE: To charge the batteries, you must have the power switch in the On position.
As well, you cannot listen to music while charging the batteries.
How to Associate
(Mutual Synchronization of dongle and ear-set)
1. The product is shipped with the dongle and earset already associated. Customers do not need
to reassociate them.
2. If association is lost, or if you want to associate a new Kleer-based dongle or earset, the
following steps need to followed to associate the units.
NOTE: association needs to only be performed once.
3. Make sure the product is fully charged. Open Protection Cover, turn the Power switch On, and
wait for the LED to start flashing slowly. Press and hold Secondary power button until LED is
on and no longer flashing.
4. Repress and hold down the Secondary power button on both dongle and earset for at least 7
seconds continuously until LED starts flashing rapidly.
6. A slowly turning off LED means the dongle and earset are trying to associate.
7. Association is completed, and the units will enter enrolment mode and then go into data
transfer mode automatically. Once associated, you will not need to associate dongle and
earset again.
