How to test an WR44V2 step by step.
Page | 3
1
INTRODUCTION
1.1
Outline
This guide will enable a competent technician to test the hardware of a WR44V2 router.
If the tests in sections 4 – 11 all complete without a problem then the router can be returned to
service. If not please follow the advice in the documentation below for the error message you receive.
The guide makes no assumption about the state of the flash; it will work even if the system flash is
completely blank.
1.2
Assumptions
This guide has been written for use by technically competent personnel with a good understanding of
the product.
This guide assumes that there are no daughter cards fitted to the WR44. (E.g. GPS, serial, PSTN, ISDN,
Telemetry etc). If a daughter card is fitted please request additional testing steps from
This note applies only to a WR44V2
1.3
Corrections
Requests for corrections or amendments to this documentation are welcome and should be
addressed to: [email protected]
Requests for new quick notes can be sent to the same address.
1.4
Version
Version Number
Status
0.6
Draft
1.0
Completed 26/03/2015
1.1
Rebr screenshot update
1.2
Module list update
