How to test an WR44V2 step by step.
Page | 18
6
CHECK LEDS
Connect all four Ethernet ports to a switch.
Access the CLI (Command Line Interface) – this can be achieved:
Through the serial port @115200 bps
Via a telnet or SSH connection
Via the “execute a command” page of the web user interface.
Issue the “flashleds” command and check that all LEDs are illuminated. If there is an LED fault please
request an RMA with code:
“x LED failure” where x is:
ON LED
LAN 0
LAN 1
LAN2
LAN3
WLAN
DSL
LINK
SIM
ACT
Signal I
Signal II
Signal III
