Page
6
of
6
Error Messages
Display
Possible Cause
Solution
Press “POWER” no display
The 230V/AC power supply
not working or Re-
chargeable battery voltage
Check the power supply or
battery and power switch
One section of LED display
no light
The LED display is not good
in condition
To replace LED display
The display reading not
stable
To check the flatform
structure
To open the platform
structure and clean the
structure
The scale can not do
calibration
To check the calibration
jumper (put to “ON” position)
To open casing and palce
the cal jumper ON position
The scale is not accurate
The Loadcell is not good in
condition
To replace the new Loadcell
Operation Mode
Open the casing , switch the jumper ( JP1 ) to “ OFF ” position.
The function will be as follow:
Press
“T”
and
hold for 1.5
seconds
CAL
Press M
OFF
Press M
Press M
Press M
Press M
Press M
BP
LO
OK
HI
EXIT