8
Rotating Field Direction Display
The voltage tester can show the direction of the rotating
field with three-phase systems. Always hold the voltage
tester by the handles designed for this purpose. Never
touch the device beyond the handle ends. Hold the two
test tips on the measuring points to be tested. Test tip cor-
responds to L1 and test tip corresponds to L2. The applied
voltage and the rotating field direction is shown on the
LCD. The rotating field symbols (D) show the correspond
-
ing field direction (L = counterclockwise, R = clockwise).
Continuity Check
The voltage tester can also be used as a continuity checker.
Always hold the voltage tester by the handles designed for
this purpose. Never touch the device beyond the handle
ends. The continuity checker switches itself on automati-
cally when the test starts, and switches itself back off when
the test has been completed. Check for correct functioning
before beginning the test. If you connect the two test clips
to each other, you should hear a beep, and the continuity
LED should light up. If this does not happen, then replace
the batteries as described on page 12. The continuity tester
indicates resistances up to 400 k
Ω
.
1065DGMAN_20250-59 DS multifunctional voltage tester.indd 8
8/8/2017 1:37:48 PM
