Digi-Pas
®
© 2018 Digipas Technologies Inc. All Rights Reserved.
www.digipas.com
Page 8
DWL-5x000XY DATA SHEET
5. Connection Modes
•
USB mode:
Connect the USB cable from USB2.0 Standard-B Port on the control box to PC as shown in
Figure 12(a).
•
RS232 mode:
a.
Select the Serial output Switch on the control box (refer to Figure 11) to
RS232.
b. Set Pin 1 of the DIP Switch on ES-U-3001-M converter to OFF position and
the rest Pin set to ON Position.
c.
Connect cable from RS232/485 serial output on the control box to ES-U-
3001-M converter as in Figure 12(b).
d.
he connection pinout of the RS232/485 serial output is illustrated in Figure
13. The connection pinout of RS232/485 Serial Output with ES-U-3001-M
converter is illustrated in Figure 14(a).
•
RS485 mode:
a.
Select the Serial output Switch on the control box (refer to Figure 11) to
RS485.
b. Set Pin 2 of the DIP Switch on ES-U-3001-M converter to OFF position and
the rest Pin set to ON Position.
c.
Connect cable from RS232/485 serial output on the control box to ES-U-
3001-M converter as in Figure 12(c).
d.
The connection pinout of the RS232/485 serial output is illustrated in Figure
13. The connection pinout of RS232/485 Serial Output with ES-U-3001-M
converter is illustrated in Figure 14(b).
•
Bluetooth mode:
No physical connection is required to be established.
6.
The configuration is then completed. Proceed to 4. Operation to link up the PC with tilt
sensor module and control box.
a
c
b
Figure 13. Connection of the control box in (a) USB mode (b) RS232 mode (c) RS485 mode
