SECTION #2
SECTION #3
SETTING THE TRANSMITTER CODE SWITCHES-TO WORK WITH
EXISTING STANLEY GARAGE DOOR OPENERS ( Model 5062\5063 - ONLY ).
Set the transmitter using
“SETTING THE CODE SWITCHES”
instructions from section
#1 above.
Set the first garage door opener using
“SETTING RECIEVER #1 (WORKS WITH
LEFT BUTTON)”
instructions from section #1 above.
Set the second garage door opener using
“SETTING RECIEVER #2 (WORKS WITH
RIGHT BUTTON)”
instructions form section #1 above.
TRANSMITTER BATTERY REPLACEMENT
The battery in the transmitter can be checked or changed by removing the front lower
half of the transmitter. Use a coin or the curved end of the visor clip to disengage the
lower half of the transmitter front. This will expose the battery compartment.
Replacement battery must be a 9-volt.
TO REPLACE OR ADD A SET
A replacement or new transmitter or receiver may be purchased by specifying the Model
Number and the RF frequency designated on the serial tag label. The RF frequency is set
at the factory and must not be adjusted in the field. The digital code can be matched to
the companion receiver or transmitter by following the “setting” procedures above.
OPERATIONAL CHECK
To check operation, move back about 50 feet and press the transmitter button. Operation
should be reliable at this distance but enviroment and location of both the transmitter
and reciever will effect the range. Try different mounting locations and positions in the
vehicle. If operation is still undesirable, the problem may be isolated by:
1.
Checking the door operator. If the door will not open when the wall button is
pressed, the problem is likely to be the operator. If the door will open by pressing
the wall button, but not when the radio control button is pressed, the problem is
probably in the radios.
Once your have removed the battery hatch, locate the “CODE SWITCHES” above the
battery. As shown above, the left button is controlled by the right hand switch and the right
button is controlled by the left hand switch.
Before
setting the receiver code switches, you will need to set the transmitter code
switches on your model 5060\5061 or 5062\5063. We strongly suggest that you change the
code from the factory setting to provide security for your own system, and to eliminate
interference with neighboring systems.
SETTING THE DUAL BUTTON SWITCHES
Set code switch positions 1 through 10 to your personal code scheme for the left button,
any combination of “on” or “off” positions can be selected
(Note: The switch is in the
“on” position when it is depressed toward the number.)
. We strongly urge that several
coding schemes be avoided: ALL ON; 2,4,6,8,10 ON. These positions are similar to our
or other manufactureres test positions, or are frequently used.
Repeat this step for the
right button.
SETTING RECEIVER #1 (WORKS WITH LEFT BUTTON
)
Set the receiver code switches to match the code settings you entered for the left button
switch in the transmitter, being sure both are set the same since a different setting of just
one switch will prevent operation.
SETTING RECEIVER #2 (WORKS WITH RIGHT BUTTON
)
Set the receiver code switches to match the code settings you entered for the right button
switch in the transmitter, being sure both are set the same since a different setting of just
one switch will prevent operation.
Once the codes have been set, check operation.
1
2
3
4
5
6
7
8
9
1
0
SV
81
1
2
3
4
5
6
7
8
9
1
0
SV
81
CODE SWITCH FOR
LEFT BUTTON
CODE SWITCH
FOR RIGHT BUTTON
Figure #1
