3.2.4 Compensated Out
A frequency corrected signal will leave this jack if you connect it to a mixer or
recording device. Use it to quietly compose or send an auxiliary signal to a console
etc. The comp out is located after the pre- and power amp, so it is a must that the
amplifier is running either with a speaker or a loadbox (THD HotPlate or similar).
3.2.5 Speaker Connections
There are 5 speaker outputs available on the rear panel. They are labelled
according to the intended impedances:
16 Ohm: connect any 16 ohms guitar cabinet to this jack.
8Ohm: connect a single 8 ohms guitar cabinet or two 16 ohms guitar cabinets.
4Ohm: connect a single 4 ohms guitar cabinet or two 8 ohms guitar cabinets.
WARNING: Although the Schmidt amplifier has 5 speaker outputs never attempt
to connect more speakers than rated. The safe combinations are 1x16 Ohm, 1x8
Ohm, 1x4 Ohm, 2x16 Ohm or 2x8 Ohm. Any other speaker configuration may
stress the power amplifier section and in extreme cases may lead to valve and/or
output transformer failure.
