Page 42 / 60
DIETZ
GmbH Reha-Produkte, Karlsbad Germany
Service Manual Agin, Alvaro & AlvaroMaxi
V1.0.0.
EN
TROUBLESHOOTING
Overall Condition Check
• Check all battery connections make certain they are assembled properly and not corroded.
• Check batteries have been fully charged.
• Check operation of brakes.
Table of faults
Case
Scooter won‘t start
Action
Check the power key switch is turned fully „on“. If it is, the battery condi-
tion indicator meter displayed on console, will be operating. If the first red
status light (green LED on Agin 6 km) is flashing once per second (flashing
twice on Agin 10 km), charge your batteries.
Case
Battery condition meter fails to operate
Action
a) Check the power key switch is turned fully „on“. If it is, the battery con-
dition indicator meter displayed on console, will be operating. If the first red
status light (green LED on Agin 6 km) is flashing once per second (flashing
twice on Agin 10 km), charge your batteries.
b) Make sure the battery charger is not plugged into the tiller charge socket,
this will prevent drive.
c) Check both battery connector (grey connectors ) . Check battery terminal
condition.
Case
The scooter stops for no apparent reason
Action
Check the circuit breaker If scooter stops for no apparent reason. It is
probably due to the circuit breaker disconnecting from the speed control
electronic box. On rear occasions, a temporary overload on the electric circuit
can occur- for instance when climbing a steep incline. If this happens, the
circuit breaker situated under the rear body cover will trip and all power to
drive system will be automatically switched off. Wait for approximately 60
seconds, switch the circuit breaker to „ON“ by entering a finger through
the access hole in the top of the rear body cover ( located under the seat)
and press the switch down. The battery gauge will light up and you are now
ready to drive again.
If the circuit breaker is continually tripping out, the main power tem-
perature was too high or there having a short circuit on the batteries main
power wires, please check, it may the user have drive scooter under a high
current or the main power wires have to replace.
