Equipment
Maintenance
and
Repair
© Diebold Election Systems, Inc. 2002 AccuVote-OS Hardware Guide
49
•
three-wire deflector connector cable
•
main serial port cable
•
modem serial port cable
•
two-wire modem power cable
•
ballot reader serial cable
•
static discharge straps
Before reconnecting the ribbon cables ensure that all locking eject levers are splayed outwards.
6. Plug the four-wire power supply connector into the male connector next to the printer
assembly on the CPU board.
7. Plug the three-wire deflector connector cable connector into the male connector on the right
hand side of the four-wire power supply cable.
8. Press the main serial port connector into the header located on the right hand side of the
deflector connector cable.
The connector should be oriented so that the ribbon cable travels towards the back of the
chassis, rather than the front of the chassis. The locking eject levers on both sides of the
headers should snap into place once the connector has been installed.
9. Press the modem serial port connector into the header located on the right hand side of the
main serial port cable. Installation of the modem serial port connector is unnecessary if no
modem is installed in the AccuVote-OS.
The connector should be oriented so that the ribbon cable travels towards the back of the
chassis, rather than the front of the chassis. The locking eject levers on both sides of the
headers should snap into place once the connector has been installed.
10. Plug the two-wire modem power connector cable into the male connector located between
the modem serial port cable and the ballot reader cable header.
11. Press the ballot reader serial cable connector into the header located in the right hand corner
of the CPU board.
The connector should be oriented so that the ribbon cable travels towards the back of the
chassis, rather than the front of the chassis. The locking eject levers on both sides of the
headers should snap into place once the connector has been installed.
12. Reconnect the two static ground connectors located on the CPU board. One is located
between the printer assembly and the four-wire power supply connector and the other is
located on the right hand side of the CPU board.
13. Reinsert the paper into the printer by folding the last ½” of the paper roll upward and feeding
it into the printer’s paper entrance slot — turn the thumb wheel clockwise in order to feed the
paper through the printer ribbon.
14. Reinstall the AccuVote-OS cover using the procedure previously described in
Replacing the
cover
.
10.7. Removing the battery
Ensure that the unit is powered off before removing the battery and the power cord is
disconnected from the unit. The position of battery terminals is illustrated in Figure 11-2 — red is
positive, black is negative.
