DIEBOLD NIXDORF BEETLE /iSCAN EASY Non Cash, Installation Manual

Page: 7 / 50

Important Notes
BEETLE /iSCAN EASY Non Cash 3
Important Notes
Appliances supplied by Diebold Nixdorf comply with the respective safety regulations for data-
processing installations and information technology installations, including electrical office
equipment for use within an office environment.
Whenever work of any kind is done on the device, as well as when data cables are plugged
and unplugged, the device must be completely disconnected from the line voltage.
After maintenance and repair work on the cash module the module must be completely
pushed into the BEETLE /iSCAN EASY and the front door must be closed before switching on
the device.

Appliances may only be repaired by authorized technicians .

Unauthorized opening of the housing or inexpert repairs can result not only in considerable
personal danger, but will also invalidate your warranty and liability protection.

Always consult the available documentation before doing any work with this appliance.

If this device is brought from a cold environment into a heated place of business,
condensation may occur. Before operation, the device must be completely dry. Therefore, an
acclimatization period of at least two hours must be adhered to.

The sockets of the house installation must be easily accessible.

Always lay the supply leads and cables in such a way that they cannot be stepped on or
tripped over.

Only touch green marked handles and knobs for moving parts.

Exchange damaged cables immediately.

In order to completely disconnect the device from the power source, turn the device off and
use the separator in the fuse box or building installation.

Make sure that no objects (such as paper clips) can reach the interior of the device, since
electrical shocks or short-circuits could result.

To avoid overheating of the system ensure that the BEETLE /iSCAN EASY receives adequate
ventilation.

During an electrical storm, data cables should not be plugged in or unplugged.

Keep the device away from vibrations, airstreams/ventilations, dust, humidity and heat.

Ensure that used parts are disposed of in an
environmentally friendly
manner.

In case of an accident (such as a damaged housing, entry of liquids or foreign objects), switch
the device off and use the separator to completely remove the device from power.

The appliance and other information technology hardware should only be connected to
electrical supply networks with a separate protective earth wire (PE). This type of electrical
supply network is referred to as a TN-S network. Do not use PEN conductors.
Also follow the recommendations set forth in DIN VDE 0100 Part 540, Appendix C2 as well as
EN50174-2, §5.4.3, National Electrical Code ANSI/NFPA 70-2005 and Canadian Electrical
Code, Part I, CSA C22.1-02. This will help prevent malfunctions.

Turn off the device when working on the cutter of the printer.