Operation
5.3.1.3
5.3.1.3
Pulling out/pushing in component carrier
1. Open the customer panel (see "
" )
1
1
By pulling out the fascia, the component car-
rier will be also pulled out.
Pulling out
2. Pull the fascia as far as possible out of the
system by holding the fascia on the left and
the right side (1).
Pushing in
3. Reverse the step above.
Slide the fascia as far as possible back into
the system by holding the fascia on the left
and the right side.
NOTE
: Do not use excessive force when slid-
ing the fascia back into the system.
NOTE
Keep your hands and fingers clear of pinch points when sliding the fascia back into the
system.
NOTE
If the component carrier is pushed in correctly, you will hear a short reply tone.
Copyright © 2020, Diebold Nixdorf
01750334554C
5-7
