!
The correct use of
wEc1
and
wTn1
units
is based on the assumption that one of them must be set as
Sensor1 and the other as Sensor2:
wEc1
is always set as Sensor1 and cannot be modified while
wTn1
can
be set in the two different ways: pls refer to the software online Help for the operating instructions.
Allowed Combinations:
wEc1 - Sensor1 (1 beep at switch on) + wTn1 set as Sensor 2 (2 beeps at switch on).
These are the factory
settings for the WPP001-ET system and for the wTn1 unit with black ring of the WPP001-ETT system
:
[
✔
]
+
wTn1 set as Sensor 1 (1 beep at switch on) + wTn1 set as Sensor 2 (2 beeps at switch on).
These are the
factory settings for the wTn1 units respectively with red and black ring of the WPP001-ETT system
:
[
✔
]
+
Wrong Combinations:
wEc1 - Sensor 1 (1 beep at switch on) + wTn1 set as Sensor 1 (1 beep at switch on):
[
✘
]
+
Both the wTn1 modules set as Sensor 1 (1 beep at switch on) or set as Sensor 2 (2 beeps at switch on):
[
✘
]
+
[
✘
]
+
!
7
User Manual
PulsePen
- V. 4.6
