Page 12
For technical questions, please call 1-888-866-5797.
Item 64684
Sa
FE
ty
Op
E
ra
ti
O
n
Maint
E
nanc
E
S
E
tup
Water tray and pump Setup
1. From the left side of the saw, place the Water
Tray (drain plug end to the right) on the lip
at the bottom of the Water Tray Frame.
2. Slide the Water Tray in under the Table until it
hits the stops on the other side of the Frame.
3. Place the Pump (167) into the Pump Basin. Press
down firmly on the Pump to attach its suction feet
to the bottom of the Water Tray. Connect the
Clear Hose to the barbed Hose Connector fitting.
note:
Make sure the Hose doesn’t contact the bottom
of the Table and interfere with Table movement. Adjust
the position of the Hose or Pump if necessary.
4.
Make sure your hands are dry and the tile
Saw is unplugged.
Push back rubber boot on
the Pump Outlet and plug Pump Power Cord into
Outlet. Pull rubber boot back into place to cover
the connection and help keep water off plug.
Mounting Saw to Stand
1. Lock the Toggle Table Stop by pulling up on it
and turning it until the slot in the center of
the Stop is horizontal (left to right).
2. Pull the Table to the front of the Frame.
From under the right side of the Table, align the
hole in the rail with the pin in the Table Lock Lever.
Push the pin into the rail, locking the Table.
3. With assistance, place Saw on Stand.
Align the holes on the Water Tray Frame
with the holes on the Stand (stand and
mounting hardware sold separately).
4.
Insert M8 x 20 Socket Head Cap Screws through
Ø8 Washers and into holes. Tighten securely.
M8 x 20
Screw
Stand
Ø
8
Washer
Mounting Saw to Stand
Water tray
Frame
Water
tray
Hose
Hose connector
pump
Basin
pump
Outlet
pump
power cord
pump
Water Tray / Pump Setup
