Diamond J-Drive User Manual Download Page 3

Page: 3 / 3

Powering

Changing the battery

Changing the standard 9V battery ﬁrst requires the removal of the four back corner

screws of the pedal. The battery clip is attached to the inside of the back plate - gently

pull the back plate off so as not to strain the connecting wires between the battery clip

and main circuit board. After replacing the battery, carefully place any slack in the con-

necting wires into the box cavity, and replace the back plate with the four screws, taking

care not to pinch the connecting wires.

Using a 9V adapter

Any standard 9V DC negative pin AC adapter for effect pedals can be used to power the

Diamond Drive. The insertion of the AC adapter plug automatically removes the internal

battery from the circuit.

Warranty

Diamond Pedals carry a full ﬁve year warranty on registered products - make sure to

send us your warranty card! The warranty is simple - if you have a problem, call us,

send us the pedal if necessary, and we’ll make it right.

Summary of Contents for J-Drive

Page 1: ...hen the pedal is in overdrive Remember to protect your hearing and wear appropriate hearing protection when play ing loud Design Features True bypass signal path Dual function clean boost lead boost a...

Page 2: ...boost and drive are enable simultaneously Gain This adjusts the gain of the clean boost section If only the clean boost section is enabled this is the only control that effects its operation If both...

Page 3: ...con necting wires into the box cavity and replace the back plate with the four screws taking care not to pinch the connecting wires Using a 9V adapter Any standard 9V DC negative pin AC adapter for ef...