MACHINE OPERATION
PRIOR TO VACUUMING CARPETS
1) Inspect power cable and extension
cable for damage. Replace cable if
damage is found.
2) Ensure filter bag is properly installed
NOTE: Never operate machine
without filter bag installed. This
could cause damage to the vacuum
motor.
3) Set proper height adjustment for
carpet being cleaned.
CARPET VACUUMING
1) Depress foot pedal and lower vacuum
head to floor.
2) Turn on power switch.
3) Operate by using standard vacuuming
procedures.
4) Check bag periodically to see if it is
full. Replace if necessary.
5) To clean under desks or other tight
areas, depress the foot pedal an
additional time to lower the handle
even further.
OPERATING HINTS
1) Overlap cleaning path by approx. 2
inches
2) Work away from power outlet and
power cable in order to avoid damage
to the power cable.
3) Occasionally check the bag for
fullness & replace as necessary.
4) If brush stops spinning, there may be
an obstruction in the brush. Unplug
the power cable, raise the brush off
the floor and check for an obstruction.
Check & reset the brush circuit
breaker located on the bottom of the
brush housing.
USE OF ACCESSORY TOOLS
NOTE: Accessory tools are available as
an option. Kit VA51061 includes:
Dusting brush, crevice tool, upholstery
tool, 8
’
vacuum hose, etc.
1) Machine must be in upright position
whenever using attachment tools.
2) Remove vacuum hose on the vacuum
intake port on rear of machine.
3) Connect (optional) 8
’
vacuum hoses
to intake port & connect desired
accessory tool to end of hose.
4) Turn on vacuum switch and operate
tool using normal vacuuming
procedures.
Diamond Products
-5-
Operator's Manual
