Diamond Multimedia Viper V770, User Manual

Page: 10 / 32

6
Setting the Standard VGA Under Windows NT 4.0
To set your display to Standard VGA under Windows NT 4.0:
1. From the Start menu, go to Start > Settings > Control Panel , then
double click on Display . The Display Properties sheet appears.
2. Click on the Settings tab, then click the Display Type button.
3. Under Adapter Type , click on the Change button. The Change Display
window appears.
4. Under Manufacturers , select Standard Display Types . Under Display ,
choose
VGA Compatible Display Adapter
.
5. Click on OK . You may need to insert your Windows NT 4.0 CD-ROM.
6. Click on Close and OK to accept the changes.
7. Shut down your computer. You are now ready to remove your old
graphics card and install your new Viper V770 board.
Note— You should have the latest Service Pack for NT 4.0 (Service Pack 4)
loaded for the Viper V770 to operate properly. Service Pack 4 is available
from Microsoft’s web page, www.microsoft.com.
After you have completed the steps above and removed your old graphics
card, you can continue with the procedures below to install your Viper V770
board.
Installing Your Viper V770 AGP Board
Installing your card should take just a few minutes. Please note that the
illustrations provided in this section are for instructional use only; the card
shown may look different than the one you purchased.
To install your AGP
card, follow these steps:
1. With the power off, remove your computer cover and locate the AGP slot.