background image

11

WARRANTY

THIS WARRANTY IS NOT TRANSFERABLE AND APPLIES ONLY TO THE ORIGINAL PURCHASER OF THIS PRODUCT 
IN ITS ORIGINAL INSTALLATION. Original purchaser must reside in the United States and be able to provide proof of 
purchase and installation with the sales receipt and completion of online registration from the authorized DAT retailer that 
sold and installed the product.

Should a manufacturing defect occur during above said warranty period, DAT will replace or repair the defective product 
with a product of the same or equivalent value and performance, at DAT’s discretion.

Damage or failure caused by any of the following is not covered under this warranty policy: negligence, improper use, 
abuse, product modification, unauthorized repair attempts, accident, acts of God, misrepresentations by DAT retailers, and 
improper/inadequate packaging during return shipping.

Warranty is void if serial numbers have been removed, altered or defaced.

In the event a DAT product should require service, you should visit the authorized DAT retailer you purchased the product 
from and they can expedite your claim. All claims must fall into the guidelines listed above and be accompanied by a copy of 
the original sales and installation receipt from that authorized DAT retailer.

Product returned for warranty service must be freight-prepaid, properly packaged and clearly marked with the Return 
Authorization (RA) number issued by DAT. Any product returned to DAT that is improperly packaged, does not have a 
RA number clearly marked on the package, or never received a RA number, may be refused upon delivery. DAT does not 
assume responsibility for lost or misdirected product.

Repair or replacement under this warranty is the exclusive remedy of the consumer. DAT shall not be liable for any 
incidental or consequential damages for breach of any expressed or implied warranty on this product. Some states do not 
allow the exclusion or limitation of incidental or consequential damages, or allow limitations on how long an implied warranty 
lasts, so the above limitations or exclusions may not apply to you. This warranty gives you specific legal rights and you may 
also have other rights that may vary from state to state.

Customers outside the United States should contact their local sales office to obtain information on pricing, exchange unit 
availability, instructions, service and warranty/non-warranty replacement or repair.

Diamond Audio Technologies

3761 SOUTH HILL STREET 
LOS ANGELES,CA 90007
Tel: 213-261-4161
Fax: 213-246-2423
Web: diamondaudio.com

Service/Tech Support:

213-261-4161

Tech Support Email

[email protected]

SERVICE

Summary of Contents for MOTORSPORT MP525













Reviews: