H65A/S Speaker Manual 2013.indd Spread 3 of 4 - Pages(6, 3)
MOUNTING
Screw Clips
Mounting Ring
Gasket
Mounting Screws
Mid-bass Driver
Tweeter
Mounting
Cup
Clamp
Ring
COMPONENT SYSTEM CONNECTION
CROSSOVER
Optional RAF
Amplifier
Tweeter
Mid-bass
Driver
The following illustration shows how to connect one channel of the HEX component system. The removeable plug has the
connections silkcreened on it so you do not have to have the crossver present to wire it up.
When flush or surface mounting tweeters, make sure desired
location can accommodate the hole sizes and depth required.
Mount cup using provided hardware flushmount illustration
shown on right. Mount surface cup with provided screws in
tweeter mounting kit. Snake speaker wires through tweeter
cup, connect tweeter to wires and snap tweeter into cup by
pushing down gently. Be careful not push on the center of the
tweeter grill.
Each HEX component system comes with a pair of model specific adjustable crossovers giving you attentuation and phase
adjustments. The tweeter adjustment has settings for -2dB of attenuation, OdB or +2dB of gain. There is also a “Phase
switch” that you may use in different application/locations to correct for acoustical phase issues casued by placement of the
drivers in the vehicles particular enviroment.
Removeable
Plug
Tweeter Attenuation Switch/
Tweeter Phase Switch 0-180 Degrees
MID-BASS MOUNTING
TWEETER MOUNTING
The illustration above shows the parts included and correct mounting assembly of the HEX
component mid-bass drivers. Grill is optional. Be sure to check the available mounting depth
before installation begins. Use of the foam gasket is recommended to ensure a proper seal
between the speaker and mounting surface.
4
5
©2014 Diamond Audio. All rights reserved.
(a division of CV & DA Holdings, lnc.)
©2014 Diamond Audio. All rights reserved.
(a division of CV & DA Holdings, lnc.)
