www.diamir.com
DIAMIr
Service Manual for specialist dealers
5
3.2
Mounting
1. Put the rear plate (Eagle / Freeride Pro) together with the heel elevator (5) and position it over corresponding holes and screw it
on tightly with a screwdriver (N° 3; Pozi-Drive).
In order to mount the rear support plate of the model Freeride Pro correctly, first tighten the front screw then the other three
screws of the rear support (Picture 3.2 A).
2. Move the heel elevator (5) up one level. Place the binding on the ski and centre the end piece of the central rail (4) in the heel
elevator (Picture 3.2 B).
3. Screw in the pre-mounted screws of the hinge support (12) half way so that the binding can be adjusted (Picture 3.2 C).
Lift the binding 90° (Experience and Freeride Plus) in order to screw in the two rear screws of the hinge support (Picture 3.2 D).
4. Make sure that the end piece (4) of the central rail is correctly centred in the heel elevator (5). If needed adjust by alignment of the
hinge support and tighten the screws with a tightening torque of max. 5 nm.
5. If there is a protective foil on the vitro don’t forget to take it off.
Picture 3.2 a
Picture 3.2 B
Picture 3.2 c
Picture 3.2 D
4 Mounting accessories
4.1
Compatibility of accessories
Only use original Diamir ski brakes and crampons which correspond to the model and to the width of the ski.
the crampons are only for use in hard snow conditions and never on rock or on other hard ground.
in mm
Eagle
Experience
Freeride Pro
(black /
Picture 4.3 A1
)
86
—
(black /
Picture 4.3 A2
)
110
—
(red /
Picture 4.3 B
)
86
—
—
78
—
—
100
—
—
Bag for crampon
80
l
90
l
100
l
115
Safety leash with heel plate
(26)
(instead of ski brake)
l
Return spring
—
—
l
standard equipment
optional equipment
ACCESSOrIES
Ski brake
(25)
Axion
crampon
Standard
(Picture 4.3 C)
ski width till …
