MODEL BMG-780 GRINDER
SECTION 7
MAINTENANCE
48
OPERATING MANUAL
MARCH 2009
Grinding & Polishing
As previously mentioned in Section 5.1 Initial operation, we recommend
conducting initial repair work on the machine with the support of personnel, by
taking this advice, maintenance personnel get the opportunity to be trained by an
expert on the machine.
Only repair work that could occur within the bounds of regular operation
of the machine, or work that is required to replace wear parts, will be
described.
If parts or components are to be replaced, the following sequence(s) of
maintenance must be followed.
It is advisable to stock all spare or wear parts that cannot be obtained quickly. As
a rule, production standstill periods are more expensive than the cost for carrying
the corresponding spare part.
Screws that have been removed must be replaced with those of the same quality
(strength, material) and design.
7.3 REPAIRING
Prior to any repair work on the machine and its drives, secure
the machine against unintentional activation. See Section 2.6.
Use of non-original replacement components or wear parts may
void the machine warranty
.
Summary of Contents for BMG-780 ULTRAPRO
Page 32: ......
