DiamaPro Systems DX26-P, Owner'S Manual

Page: 6 / 24

2. MAINTENANCE & REPAIR (cont).
FREQUENCY
PROCEDURES
FIRST 8 HOURS (BREAK IN PERIOD)
EVERY 50 HOURS
EVERY 100 HOURS
EVERY 250 HOURS
250 HOURS
500 HOURS
1000 HOURS
-CHANGE OIL & OIL FILTER
-INSPECT CLUTCH BELT TENSION
-TILT MACHINE BACK AND INSPECT GEARBOX SEALS AROUND EACH GRINDING HEAD
-CHANGE OIL & OIL FILTER
-CHECK & CLEAN OIL COOLER FINS
-REPLACE SPARK PLUGS
-INSPECT CLUTCH BELT TENSION
-CHECK BATTERY WITH LOAD TESTER. REPLACE IF NEEDED
-REPLACE PRIMARY & SECONDARY AIR FILTER
-CHECK VALVE CLEARANCE. ADJUST IF NEEDED.
-INSPECT RUBBER IN FLEXIBLE TOOL PLATE MOUNT FOR DAMAGE OR EXCESSIVE
WEAR. REPLACE AS NEEDED
-REPLACE CLUTCH BELT
-INSPECT ELECTROMAGNETIC CLUTCH. REPLACE IF NEEDED.
-INSPECT ANTI-ROTATION. REPLACE IF NEEDED
-REPLACE GEAR OIL
General Cleaning
Engine Air Filter
Grinding Heads
Engine Oil Level
Wheels & Wheel
Bearings
Dust Control System
Check Propane Level &
Supply
Battery
At each start
At each start
At each start
At each start
At each start
At each start
At each start
Weekly
Or every 40 hours
NAME OF
OPERATION
FREQUENCY PERSON IN
CHARGE
OPERATING INSTRUCTIONS
STATE OF
MACHINE
MECHANICAL PARTS
Machine stopped /Power
sources disconnected
Machine stopped /Power
sources disconnected
Machine stopped /Power
sources disconnected
Machine stopped /Power
sources disconnected
Machine stopped /Power
sources disconnected
Machine stopped /Power
sources disconnected
Machine stopped /Power
sources disconnected
Machine stopped /Power
sources disconnected
Wash the dirty parts with a brush and water. Lubri-
cate the parts exposed to dust; Do not lubricate the
rubber parts subjected to motion (belts, etc).
Check and Clean engine air filter if necessary,
especially if you are working in dusty conditions or
replace it; follow the instructions given in the engine
Lift the gearbox grinding head, check whether the
abrasive positioning pins are loose or damaged,
and replace them if necessary
Add oil if low or replace oil & oil filter if needed
Inspect wheels & wheel bearings for damage or
excessive wear. Replace if needed.
Inspect dust skirt and dust hoses for damage or
excessive wear. Replace if needed.
It is recommended to make sure that the propane
contains no water and not to use mixtures or diesel.
Perform this operation in a well-ventilated envi-
ronment and away from possible sources of heat
or flames. Make use of specific P.P.E. (mask) as
shown in the residual risks table of this publication.
REFER TO THE ENGINE MANUAL
The DX26-P is equipped with a maintenance-free
battery. DO NOT TRY TO FILL.
Clean the two battery poles to remove oxidation.
It is recommended to turn off the battery via the
circuit breaker on the side of the grinder when
storing or transporting the machine