Diamant F60000, Operating Instructions And Parts List Manual

Page: 26 / 52

26
2) Mount the Water Tank Bracket [QQ 3]
INSIDE of the handle supports (frame)
as shown in FIG. 1, FIG 2 and FIG. 3.
Using two (2) each of the M8
Capscrews, Lockwashers, Washers
included in the kit, secure the
Water
Tank Bracket [QQ 3] in position.
3) See FIG. 31. At the back of the
machine, to the right side of the
Dust
Port [XX] find the Hose Port Cover
[AAA] . Using the small end of the
Wrench (V) loosen the two (2) M8
Capscrews that hold this cover in
position, then rotate it counter-
clockwise until the Hose Port is
exposed. Re-tighten the M8
Capscrews until the
Hose Port Cover
is secured in its lowered position.
4) Move the Axle into the Transport
Position [E] [FIG. 11] and tilt the
machine backwards until the handles
are resting on the ground.
5) Under the front of the machine, and in
front of the
Accessory Disks (P) , find
and remove the two M8 Capscrews,
Lockwashers, and Washers that match
the pattern in the
Nozzle Bracket
Assembly (Not Shown) . Remove
these Capscrews, Lockwashers, and
Washers from the machine. This
hardware was used only to plug holes
in the gearbox.
6) Using the two (2) M8 Capscrews,
Lockwashers, and Washers supplied
in the kit, mount the Nozzle Bracket
Assembly with the hose barb fitting
toward the rear of the machine.
7) Take the free end of the Water Tank
Hose and slide a Hose Clamp [QQ 4]
loosely over the hose. Route the hose
through the side of the machine [See
FIG. 1 and the opened
Dust Port
Cover [FIG. 31] . Attach the hose to
the Hose Barb fitting on the Nozzle
Bracket Assembly .
8) Slide the Hose Clamp down the hose
until it is on the Hose Barb fitting at
the Nozzle Bracket. Tighten the M6
Capscrew, and Lockwasher that hold
the
Hose Clamp [QQ 4] .
9) Install two (2) more Hose Clamps [QQ
4] along the frame [See FIG. 1].
10) Make sure the Water Valve (QQ 1) is
closed before adding any water to the
water tank.
WARNING: DO NOT lift the machine into the
air if the Water Tank is filled with water. This
added weight will cause the balance point to
be shifted so that the machine will not lift in a
horizontal position.
11. Repairs
We carry out all repairs in the shortest possible time
and at the most economical prices. See front cover
for our address and telephone numbers.
12. Spare Parts
For a quick supply of spare parts it is essential to
quote the data shown on the
Serial Number Plate [VV]
[See FIG. 13] fixed to the machine. Make note of this
information & the purchase date below, and on the
front cover of this document for quick reference:
Model:
_____________
Serial No:
_____________
Date:
_____________