Dialogic 1000Series, User Manual

Page: 39 / 326

Dialogic
®
1000 and 2000 Media Gateway Series User’s Guide 39
Media Gateway Configuration
• For DMG1000 models, select Telephony Switch Type (See Telephony Switch Type
parameter information in Section 3.10, “TDM Digital Parameters” , on page 137.)
Note: The Telephony Switch Type parameter does not apply to the Models DMG1008MTLDNIW,
DMG1008LSW, DMG1004LSW, DMG2030DTIQ, DMG2060DTIQ, and DMG2120DTIQ.
• For DMG2000 models, select:
– Line Mode ( Section 3.8.1.1, “Line Mode” , on page 111)
– CAS Protocol ( Section 3.8.1.2, “Signaling Mode” , on page 111 and Section 3.8.2.1,
“T1 CAS Protocol” , on page 113) or ISDN Protocol ( Section 3.8.1.2, “Signaling
Mode” , on page 111 and Section 3.8.3.4, “ISDN Protocol” , on page 121)
8. When prompted that the parameters have been successfully configured, type restart at the
PIMG> prompt to restart the Media Gateway.
You should now be able to connect to the Media Gateway from the Web Interface using the
newly configured IP Address.
2.3 Changing the Password
The steps for changing the password are described in the following procedure:
1. Start your Web browser.
2. In the Web browser address box, enter the IP address of the Media Gateway that you wish to
access.
3. When the System Login Web page appears, enter the user name and current password in the
boxes provided and click on the Log On button.
Note: The user name and password are case sensitive.
4. Once the login has been accepted, the Media Gateway Status/Configuration Web page will
appear. Select the Password Web page from the Configuration menu on the left side of the
page.
5. Enter the current password in the Old Password box.
6. Enter the new password in the New Password box.
7. Enter the new password a second time in the Confirm box. Then, click on the Change button
to replace the old password with the new password.
2.4 Configuration Procedure
The Media Gateway is configured using a Web interface.
To change configuration parameter values through the Web interface, use the following procedure:
1. From a workstation connected to the Media Gateway via the Ethernet, start the Web browser.
2. Enter the IP address assigned to the Media Gateway. For example:
http://10.12.13.74