Dialogic 1000Series, User Manual

Page: 284 / 326

284 Dialogic
®
1000 and 2000 Media Gateway Series User’s Guide
Diagnostics
9.3 TDM Self Verification Test
TDM Self Verification is discussed in the following topics:
• TDM Self Verification Test Overview
• TDM Self Verification Test Operation
9.3.1 TDM Self Verification Test Overview
The TDM self verification diagnostic tool is a Web page user application that can be used to
provide verification of PBX compatibility and also to confirm the Media Gateway configuration
values relating to the PBX interface are valid.
9.3.1.1 Features
Currently the TDM self verification diagnostic provides the ability to verify the following
operations:
Initiate Call
• Originate an outbound PBX call
• Receive outbound call progress (alerting)
• Send and Receive DTMF digits
• Receive far-end disconnect supervision
Answer Call
• Answer an incoming PBX call
• Receive call party identification (CPID)
• Send and Receive DTMF digits
• Release an active call
Transfer Call
• Transfer a connected PBX call
• Answer an incoming (transferred) PBX call
• Receive call party identification (CPID) during incoming transfer
• Receive DTMF digits after transfer completed
Message Waiting
• Send message waiting notification request (Set)
• Send no message waiting notification request (Clear)
9.3.1.2 Restrictions
The TDM self verification diagnostic is currently only available on PBX interfaces and protocols
that allow the interfaces and channels to be individually assigned extension numbers and allows
outbound and inbound call routing from one interface and channel to another.
Note: The TDM self verification diagnostics is not available on any ISDN protocol.