Document No.
9100-127-2044-99 Rev C
Release Date: August 2020
Dialight Corporation 1501 Route 34 South Farmingdale NJ 07727
Tel: 732.919.3119 Fax: 732.751.5778 Web: www.dialight.com
Page 1 of 21
Introduction
This manual is for orientation and function of the Power Supply only. Individual manuals
are supplied for each component of Dialight’s Safesite® Medium Intensity L864/L865
Dual Strobe System.
NOTE:
For Controller connections and wiring refer to its manual.
NOTE:
For Flash Head connections refer to its manual.
NOTE:
For Photocell connections refer to its manual.
Included in this manual
•
WARNINGS
•
Classifications for use
•
System overview
•
Installation Tips and requirements
•
System Installation Requirements for EMC and Lightning Immunity
•
Power Supply Specifications & Electrical Parameters
•
Mechanical Dimensions of Power Supply Enclosure
•
Replacement Part Numbers
•
Refer to product labelling for applicable
installation locations
•
DO NOT let any supply cords touch hot
surfaces higher than cord or fixture ratings.
•
DO NOT mount near gas or electric heaters
•
Equipment should be mounted in locations
and at heights where it will not be subjected to
tampering by unauthorized personnel.
•
The use of accessory equipment not
recommended by the manufacturer may cause
unsafe conditions.
•
DO NOT use this equipment for other than
intended use.
•
Pictures of the install are required for
warranty purposes
SAVE THESE INSTRUCTIONS!!
•
The operation and maintenance must be carried
out by authorized personnel.
•
Repairs and Installation must only be carried
out by a qualified electrician.
•
Only genuine Dialight replacement parts must
be used when unforeseen repairs are required.
•
Observe the national safety rules and
regulations during installation!
•
Earth Grounding is required throughout the
install process. Failure to do so could void all
warranties!
•
No alterations are allowed without the
agreement from Dialight Corp. Alterations other
than written in this manual will void all
warranties.
•
Ensure that all conduit or external cable feeds
have been installed so water or condensation
cannot enter the enclosures.
Hazardous Location Medium Intensity Power Supply Manual
READ AND FOLLOW ALL SAFETY INSTRUCTIONS
