9100RHB005500 REV A
Dialight, 1501 Route 34 South, Farmingdale, NJ, USA 07727
Tel: 732 919 3119 Fax: 732 751 5778 www.dialight.com
Page
3
Reliant High Bay Replacement Power Supplies
5.
Collect the replacement power supply and install into luminaire by sliding fully into the mounting tabs. Install 2x 8-32 SEMS screws loosely to the
front of the power supply. Slide the supply forward fully onto the 8-32 SEMS screws. Torque to 14-16 in-lbs.
6.
Add zip tie and connect plugs (shown below).
7.
Tilt the access cover closed, engage the snap features and tighten the captive screw. Torque to 14-16 in-lbs.
a.
If the luminaire contains an occupancy sensor, replace the sensor lens by sliding it onto the sensor and then twisting ¼ turn clockwise
until snug.
8.
Power the luminaire on and insure proper function.
a.
If the luminaire contains battery backup, press and hold the battery test button for 5 seconds to ensure the luminaire goes into battery
backup mode.
Official Statement
All statements, technical information, and recommendations contained herein are based on information and tests that
Dialight believes to be reliable. The accuracy or completeness thereof is not guaranteed. In accordance with Dialight “Terms
and Conditions of Sale” and since conditions of use are outside our control, the purchaser should determine the suitability of
the product for his or her intended use and assumes all risk and liability whatsoever in connection therewith.
Add Zip Tie
Plug In
Connector
Plug In
Connector
