Step by step instructions
LAC 142 / CHO 142 / TRI 142
Serial measurement
Diaglobal GmbH · Köpenicker Straße 325 · 12555 Berlin · +49 (0)30 6576 2597 · [email protected] · www.diaglobal.de
1. Wash out samples from
capillaries into cuvettes with
micropipetter
4. Blank adjustment:
Insert cuvette with samples (fig. 2)
into photometer, blank is stored in
memory
Ensure correct order of samples!
3. Switch on photometer with
ON/ENTER
Wait for device check, confirm
with ON/ENTER
Select the required test,
confirm with ON/ENTER
5. After blank adjustment of
the last cuvette replace all
screw caps against starter
caps
ON
ENTER
ON
ENTER
M1 LAC
Sample 01
insert
8. Read the measured value of
cuvette 1, remove cuvette
Insert cuvette 2, read the
measuring value, remove
cuvette, etc.
6. Turn cuvettes upside down
several times at the same
time
7. First press ON/ENTER
Thereafter insert cuvette 1 in
photometer
Timing appears, wait for result
ON
ENTER
M2 LAC
Sample 01 00:30
Measuring
M1 LAC
Sample 19
insert or
ENTER
2. Screw on cap
Turn cuvette upside down
several times
9. Repeat the process until the
measured value of the last cuvette
is displayed
Pay attention to correct assign-
ment and sequence of samples!
ON
ENTER
M2 LAC
Sample 19
5.28 mmol/L
