Di4 Acqua Rs3, Original Instructions Manual

Page: 52 / 120

52
User maintenance and Repair
Disconnect from the electrical power supply before carrying out user maintenance.
Turn off the water supply at the tap and press the trigger to discharger the pressure.
Lubricate the fixing periodically using the lubrication oil.
When the water pressure is not consistent or too high, it shows the signal of defect hose or accumulation
of the Calcium in the nozzle.
Turn off the machine immediately.
Use the nozzle cleaner to clean the hose and the water inlet filter.
Change the defective filter.
Make sure that the machine is clean and clean the components when necessary.
Follow the operation-instructions for the different parts. Pluggable ring-nuts are used to connect the
gun, hose and other parts.
The seals of the ring-nut connections shall not be damaged
Turn the detergent tank and fasten it to the foam nozzle.
Connect the foam nozzle with the jet gun.
Turn on the machine. input the cleaning agent by a proportion of 1%. Warning: Use only the cleaning
agent supplied by the manufacturer or their after-sales service.
Keep the appliance safe and store them carefully in a secure dry place. Always store the machine out
of the reach of children.
Avoid storing the washer in temperatures below frost point.
Cut off the power if the appliance malfunctions.
Problem and solution
Warning! Disconnect from the electrical power supply before carrying out user maintenance.
If the mains cable is damaged it must be replaced by the manufacturer, or its service agent or similarly
qualified person to avoid a hazard.
Possible problem and solution
Problems Causes Possible solutions
The machine does not start The machine is not plugged in Connect the machine to a suitable
outlet
Defective plug Contact your service center.
The fuse is blown
Defective extension cable Use the machine without the
extension cable and change the
defective cable
Fluctuations of pressure The pump sucks the air Check that hoses and fittings are
waterproof.
Dirty, worn or jammed valves Contact your service center