JINDLU04 Rev G 21/04/16
Operating Instructions
Read the ‘General Guidance’ Section at the
start of these instructions before operating
your stove for the first time.
IMPORTANT!
-
Do not hang pictures,
televisions or combustible ornaments above
the stove, as these could be damaged and
could potentially create a fire hazard
(For
more information read the ‘Clearance
Distances to Combustibles’ section of the
installation instructions).
WARNING! – This appliance will be hot when
in operation and due care should be taken.
The supplied operating tool or gloves may be
used to open the door and operate the air
controls.
R
ECOMMENDED
F
UEL
This appliance is designed and approved to
burn wood logs with a moisture content not
exceeding 20%. The maximum recommended
log length is 250mm (10”) and the maximum
recommended log diameter is 100mm (4”).
Burn only dry, well seasoned wood, which
should have been cut, split and stacked for at
least 12 months, with free air movement
around the sides of the stack to enable it to
dry out. Burning wet or unseasoned wood will
create tar deposits in the stove and chimney,
increase harmful emissions and will not
produce a satisfactory heat output.
Do not burn waste, mineral fuel, or treated
or painted wood in this appliance.
A
IR
C
ONTROLS
Installed and used correctly this stove will
burn cleanly and efficiently. Therefore, to
avoid the disappointment of poor
performance or dirty glass, please familiarize
yourself with the controls and their
recommended settings before use.
To access the air controls press on the door
handle to release it from the latch and swing
it to the right.
If the door handle is swung past the point
where resistance is felt the door will be
unlatched and may swing open.
When the stove is hot the door handle can be
released by pressing the end of the operating
tool against the arm below the handle. This
will prevent damage to the paint.
Alternatively a glove can be used.
Ignition Air control
–
regulates air flow
directly into the firebed. This is used when
lighting from cold or when reviving a fire that
has nearly burnt out. Turn clockwise to open
and anti- clockwise to close.
The Ignition Air
Control must be closed once the fire is
established.
Combustion Air Control
Ignition Air Control