Smooth, even notches can be cut in all types of ductile material with the Di-Acro Notcher. It elimi-
nates the high cost of special dies required for each different notching operation and does away
with time wasted in punch press setup—you simply adjust the Material Gauge and you’re ready for
production.
Both power and hand operated models of this precision machine are available. They are equally
useful in the experimental shop or on the production line.
Adjustable gauges are used to locate a notch of any dimension at the corner of a sheet of material
or at any position along the edge of the sheet. Notches greater or less than 90 degrees can be
obtained in two operations and many straight shearing operations can also be performed. The
hardened and ground Triangular Ram used in the Di-Acro Notcher will provide years of continuous,
trouble-free performance and assure a clean cut free from rough edges or burr.
SETUP PROCEDURE
POWER NOTCHER
Except for wiring, the power operated Di-Acro Notcher is delivered ready for operation. To set up,
simply hook up wiring, adjust Gauges for the proper size notch and machine is ready for production.
WIRING
Cost includes wiring for either of the follow-
ing standard electrical systems.
110 or 220 volt single phase
220 or 440 volt three phase
Hook up lead-in wires and switch Motor on
to check the direction of Flywheel. It should
operate in a counter-clockwise direction as
indicated by the
arrow
.
If the lead-in wires have been incorrectly
hooked up, Tripping Mechanism will fail to
operate. To remedy this, simply reverse any
two lead-in wires.
TO PREVENT SERIOUS BODILY INJURY
AND DAMAGE TO THE MACHINE
BOLT THE MACHINE TO THE STAND
AND THE STAND TO THE FLOOR
CAUTION
WIRING
2
