7
I F U
Using Bure Walker with Gait Training Kit 56-388:
•
The support harness has four blue straps with a plastic
buckle allowing for adjustments in length, having steel
carabiner clips at the ends to be fasten to the gait walker.
The carabiner clips on to the metal mounts placed under
the table of the Gait walker.
•
Apply the walker support harness by clipping on the two
front carabiners to the front mounters, one on each side
of the table.
•
Place the patient standing up in the walker. Pull back the
harness in between the legs and clip on the carabiners
to the back mounters, one on each side of the table.
Adjust the harness to the patient by pulling in the back
strap loops.
•
Observe!
Intended use of the trainer support harness is to
practise walking.
It is not
a sitting or lifting aid
.
Standing Plate
Attach standing plate by hooks on the main frame of the
walker.
Raising/Lowering the Frame, Bure electrical actuator
Adjust the height with the aid of the hand control UP and
DOWN arrows.
Raising/Lowering the Frame - Bure gas actuator
Release the gas strut by moving the handle upward (the gas
strut will raise the Walker). Let go of the handle at the desired
height (the gas strut a locked).
Release the gas strut by moving the handle upward. Use your
body weight to press the frame down. Let go of the handle at
the desired height (the gas strut will lock).
Hand Control
has charge indicator / battery (low, medium, high)
and Service indicator.
Service indicator – flashes red after 11 months’ operation.
Constant light (red) after 12 months’ operation. This indicates
need of yearly maintenance.
