15
Quick Setup Guide
Quick
Setup
Guide
1.3.9 IrDA Connector
1 VCC
2N. C.
3 IRRX
4 Ground
5 IRTX
The sequence of the pin functions
on some IrDA cable may be
reversed from the pin function
defined on the system board. Make
sure to connect the cable to the
IrDA connector according to their
pin functions.
1.3.10 Fan Connectors
1 Ground
2Power
3 Sense
1 Ground
2On/Off
3 Sense
1 Ground
2On/Off
3 Sense
CPU Fan
System Fan
Second Fan
devices. Only two drives can be configured as RAID. Since both of these
drives must be in Master mode, striping or mirroring must be done
between 2 RAID IDE channels; not between 2 drives that are chained on
the same channel. PCI slot 3 and RAID IDE use the same IRQ. If you are
using add-in cards such as PCI audio card or SCSI card, please do not install
it into PCI slot 3.
The RAID LED connector (J24) is used to connect a LED cable connector.
The LED will light when the hard drive is being accessed.
