11
1
Introduction
Wake-On-LAN
The Wake-On-LAN function allows the network to
remotely wake up a Soft Power Down (Soft-Off) PC.
Your LAN card must support the remote wakeup
function. Refer to “Wake-On-LAN Connector” in chapter
2 and “Resume On LAN” in the Power Management
Setup section in chapter 3 for more information.
Important:
The 5VSB power source of your power supply
must support
≥
720mA.
Wake-On-Keyboard/Wake-On-Mouse
This function allows you to use the keyboard or PS/2
mouse to power-on the system. Refer to “Jumper
Settings for Wake-On-Keyboard/Wake-On-Mouse” in
chapter 2 and “Keyboard/Mouse Power On” in the
Integrated Peripherals section in chapter 3 for more
information.
Important:
• The power button will not function once a
keyboard password has been set in the “KB
Power On Password” field of the Integrated
Peripherals submenu. You must type the
correct password to power-on the system. If
you forgot the password, power-off the system
and remove the battery. Wait for a few seconds
and install it back before powering-on the
system.
• The 5VSB power source of your power supply
must support
≥
720mA.
