31
2
Hardware Installation
2.4.2 Jumper Settings for Wake-On-Keyboard/Wake-On-
Mouse
This Wake-On-Keyboard/Mouse function allows you to use the PS/2
keyboard or PS/2 mouse to wake up a system from the S3/S4/S5
state. To enable this function, set JP1 pins 2 and 3 to On.
BIOS Setting:
“Keyboard/Mouse Power On” in the Power Management Setup
submenu of the BIOS must be set accordingly. Refer to chapter 3
for more information.
Warning:
1. If JP1 was enabled with a password set in the “KB Power
On Password” field, and now you wish to disable the
keyboard password function, make sure to set the
“Keyboard/Mouse Power On” field to “Disabled” prior to
setting JP1 to disabled. You will not be able to boot up the
system if you fail to do so.
2. The power button will not function once a keyboard
password has been set in the “KB Power On Password”
field. You must type the correct password to power-on the
system.
3. The 5VSB power source of your power supply must
support
≥
720mA.
.
.
.
.
.
.
.
.
1
3
2
1
3
2
X
JP1
2-3 On: Enabled
1-2 On: Disabled
(default)
