www.d
fi
.com
27
Chapter 4 Ports and Connectors
Chapter 4
SATA (Serial ATA) Connector
7
RXN
GND
TXP
TXN
GND
1
RXP
GND
SATA 2.0 3Gb/s
• 1 Serial ATA port
- SATA port 0 with data transfer rate up to 3Gb/s
• Integrated Advanced Host Controller Interface (AHCI) controller
The Serial ATA connector is used to connect the Serial ATA device. Connect one end of the Se-
rial ATA data cable to a SATA connector on the system board and the other end to your Serial
ATA device.
The power cable must be connected from the system board’s Serial ATA power connector to
the SATA drive’s power connector in order to provide power to the drive.
BIOS Setting
Configure the Serial ATA drives in the Integrated Peripherals submenu (“OnChip IDE Device”
section) of the BIOS. Refer to chapter 6 for more information.
SATA Power
Features
SATA 0
1
4
+12V Ground 5V
Front Audio Connector
1
Mic IN-L
Line OUT-R
GND
GND
NC
Key
2
10
Mic-JD
Line OUT-JD
9
Mic IN-R
Line OUT-L
The front audio connector allows you to connect to the second line-out and mic-in jacks that
are at the front panel of your system.
