45
3
Award BIOS Setup Utility
Auto
The BIOS will automatically detect the settings for you.
Disabled
The BIOS will not detect these categories.
USB Controller
We recommend that you leave this field in its default setting - Enabled.
USB Keyboard Support
By default, this field is Disabled. If you are using a USB keyboard, please
enable this function.
Onboard FDC Controller
Enabled
Enables the onboard floppy disk controller.
Disabled
Disables the onboard floppy disk controller.
Onboard UART 1 and Onboard UART 2
Auto
The system will automatically select an I/O address for the
onboard serial port 1 and serial port 2.
3F8/IRQ4, 2F8/IRQ3, 3E8/IRQ4, 2E8/IRQ3
Allows you to
manually select an I/O address for the onboard serial
port 1 and serial port 2.
Disabled
Disables the onboard serial port 1 and/or serial port
2.
Onboard UART 2 Mode
The system board supports IrDA function for wireless connectivity
between your computer and peripheral devices. You may not use
IrDA (J2) and the COM 2 serial port (CN2) at the same time. If you
are using the COM 2 serial port, make sure Onboard UART 2
Mode is set to Standard.
To use the IrDA function, follow the steps below.
1.
Connect your IrDA cable to connector J2 on the system
board.
2. Set Onboard UART 2 Mode to the type of IrDA standard
supported by your IrDA peripheral/device (HPSIR or
ASKIR).
