20
2
Hardware Installation
2.6.3 Parallel Port
The system board has a standard
printer port for interfacing your PC
to a parallel printer. It supports
SPP, ECP and EPP modes. You can
set the por ts mode in the
Integrated Peripherals setup of the
Award BIOS.
1. Install the 34-pin header connector
into the shrouded floppy disk header
(J4) on the system board. The
colored edge of the ribbon should
be aligned with pin 1 of J4.
2. Install the other 34-pin header
connector(s) into the disk drive(s).
Align the colored edge of the daisy
chained ribbon cable with pin 1 of
the drive edge connector(s). The end-
most connector should be attached
to the drive you want to designate
as Drive A.
2.6.4 Floppy Disk Drive Controller
