66
2
Hardware Installation
Restarting the PC
Normally, you can power-off the PC by:
1. Pressing the power button at the front panel of the chassis.
or
2. Pressing the power switch that is on the system board (note: not
all system boards come with this switch).
If for some reasons you need to totally cut off the power supplied
to the PC, switch off the power supply or unplug the power cord.
Take note though that if you intend to restart it at once, please
strictly follow the steps below.
1. The time where power is totally discharged varies among power
supplies. It's discharge time is highly dependent on the system's
configuration such as the wattage of the power supply, the
sequence of the supplied power as well as the number of
peripheral devices connected to the system. Due to this reason,
we strongly recommend that you wait for the Standby Power
LED (refer to the “LEDs” section in this chapter for the location
of the Standby Power LED) to lit off.
2. After the Standby Power LED has lit off, wait for 6 seconds
before powering on the PC.
If the system board is already enclosed in a chassis which
apparently will not make the Standby Power LED visible, wait for
15 seconds before you restore power connections. 15 seconds is
approximately the time that will take the LED to lit off and the
time needed before restoring power.
The above will ensure protection and prevent damage to the
motherboard and components.
Summary of Contents for Infinity NF series
Page 1: ...System Board User s Manual 935 NF4F05 300G 92440643 ...
Page 25: ...25 1 Introduction ...
Page 26: ...26 Introduction 1 ...
