DFI ICX610-C621A, User Manual

Page: 35 / 44

39
Chapter 3
BIOS SETTINGS
User's Manual | ICX610-C621A
IPv4 Source
Select how BMC IPv4 settings are configured: automatically (DHCP) or manually (Static).
IPv4 IP Address
Enter the BMC IPv4 IP address. This field is only required when using Static IP.
IPv4 Subnet Mask
Enter the BMC IPv4 Subnet Mask. This field is only required when using Static IP.
IPv4 Gateway Address
Enter the BMC IPv4 Gateway Address. This field is only required when using Static IP.
IPv6 Mode
Enable or disable Internet Protocol v6 (IPv6).
IPv6 Prefix Length
Set IPv6 prefix length.
IPv6 Static IP Address
Enter the BMC IPv6 IP Address.
IPv6 Gateway Address
Enter the BMC IPv6 Gateway Address.
X
BMC Configuration
X
User Configuration
Configure the BMC's users in this sub-menu. The settings of all the 15 users are listed in the
lower part of the sub-menu.
X
Advanced
X
H2O IPMI Configuration
InsydeH2O Setup Utility Rev. 5.0
F1 Help
Esc Exit
↑/↓ Select Item
←/→ Select Item
F5/F6 Change Values
Enter Select
X
SubMenu
F9 Setup Defaults
F10 Save and Exit
Enable/Disable IPMI Support.
Note: If changing to enable, BMC
detailed information only valid
after rebooting.
User Configuration
User ID
User Status
User Password
Channel
Privilege
Add current setting to list
-----------------------
User Id UserName
1 dfi
2
3
4
5
6
7
8
9
10
11
12
13
14
15
Advanced
[1]
<Enabled>
[1]
<Administrator>
UserStatus Channel Privilege
Enabled 1/2/3 Admin/Admin/Admin
Disabled 1/2/3 N/A/N/A/N/A
Disabled 1/2/3 N/A/N/A/N/A
Disabled 1/2/3 N/A/N/A/N/A
Disabled 1/2/3 N/A/N/A/N/A
Disabled 1/2/3 N/A/N/A/N/A
Disabled 1/2/3 N/A/N/A/N/A
Disabled 1/2/3 N/A/N/A/N/A
Disabled 1/2/3 N/A/N/A/N/A
Disabled 1/2/3 N/A/N/A/N/A
Disabled 1/2/3 N/A/N/A/N/A
Disabled 1/2/3 N/A/N/A/N/A
Disabled 1/2/3 N/A/N/A/N/A
Disabled 1/2/3 N/A/N/A/N/A
Disabled 1/2/3 N/A/N/A/N/A
User ID
There are 15 BMC users available per system. Insert a number from 1 to 15 to select which
user ID is to be configured.
User Name
Insert an alias for the currently selected user.
User Status
Enable or disable the currently selected user.
User Password
Set up a password for the currently selected user. To clear any previously configured pass-
word, press Enter and leave the new password empty.
Channel
Select a LAN Channel to configure the privilege of the currently selected user.
Privilege
Select among Reserved, Callback, User, Operator, Administrator, and No Access. The privilege
of a user ID can be set differently in different channels.
Add current setting to list
Save the setting of the current user ID's previlege of the current channel.